Sun Oct 7 You’ll need to make sure that it’s set back to 0 on system startup. Default rate control algorithm for mac to use charp. Mark Rijckenberg markrijckenberg said on Default rate control algorithm for mac to use charp [cfg] filename: Are you on battery when you try to connect? Other bug subscribers Subscribe someone else.
|Date Added:||10 November 2011|
|File Size:||33.56 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Hi, I haven’t had any problems with wireless for a while now Atberos need to make sure that it’s set back to 0 on system startup. August 10th, 5.
Atheros AR5BXB63 (Acer Aspire One Wifi) under Linux Mint — help! | [H]ard|Forum
I will be in a position to do further testing tomorrow, if needed. Asked by hunter on Is ar5bdb63 behavior the same if the power supply is connected e. August 11th, 7.
August 12th, Registering new address record for fe Well, there was no need to run that code now, although it did no harm. Cheap Ativa card works ok in gentoo.
Built-in drivers/modules, tested only on Intrepid
The Gutsy starter guide is herewhich might be able to help or at least give you some ideas. Kurian posted the following information edited here: Please follow the instructions exactly. Sections of this thread qr5bxb63 quoted below.
I would still bookmark it for future reference.
WifiDocs/Driver/Atheros – Community Help Wiki
Default rate control algorithm for mac to use charp [cfg] filename: However, some users have reported success, but could not confirm this. Your Terminal output shows this issue: Visit the Trac open source project at http: In Openhal the interface ath0 show up there aren’t any communication, the commands like iwlist return error.
Hi SonicEpsilon, Unless someone who reads this forum has your setup and responds, in the meantime your best bet is to keep atherso your thread post you didn’t post in someone else’s thread at ubuntuforums. Crash because default kernel limit stack to 4k.
Hopefully, this will enable the wireless again. Click here to join today!
Comment on this change optional. My access point is motorola. Install from YaST as Installation Source, compiling from sources not working, do not use ndiswrapper.